Services
Floor Preparation
Great care is taken when preparing surfaces to enable good bonding
before any application. Using light to heavy shot blasting, floor
grinding (diamond tipped), scabbling etc are all virtually dust free.
Floor Grinding
PSR provide floor grinding services to level out problem floors. This
is totally dust free which helps to minimise disruption to other areas
of your building & operations.
Floor Coatings & Paints
PSR specialise in Epoxy High Build Coatings with or without Non-Slip surfaces.
For areas with lighter traffic such as walkways etc. Water Disbursable Coatings can be applied.
All coatings are available in any RAL or BS colours.
Arris Repairs
Construction Joint failure can cause serious & expensive damage to
forklift trucks and may also become a Health & Safety issue. The
replacement of the joint is carried out Quickly & Effectively by
saw cutting either side of the joint, Breaking out the damaged area
& filling with Epoxy Mortar. Plus cut back through and Re-Seal to
achieve our Tried & Tested Arris Repair.
Our process leaves a Seamless Transition over the repaired joint.
Joint Re-seal
Reseal replacement
to existing saw cut and construction joints are solved by re-cutting,
cleaning out and replacement with a suitable joint sealant which still
allows for movement in the floor. This method can be applied to joints
up to 20mm wide and if done early enough you will save the cost of a
more expensive Arris repair.
Floor Screeds
These
cemiticious screeds can be put down from as little as 3mm thick, which
will upgrade existing concrete floors and give a new and improved look
to your surface.
Also used to level existing floors that have flatness issues, the screed can be laid up to 100mm thick. The materials used are very hard wearing; up to 40 newtons when fully cured. Applied by hand or pumped, for use internally and externally. An area of up to 1000m2 per day can be achieved and given minimum down-time the screed can be trafficable in 12 hours.
