|Floor Screeding for Hinchcliffe & Son - Ramp Repair
Before and After
|New Floor Screed for M&S||Floor Levelling Screed
|[click images to view larger versions]|
Cementitious industrial floor screeds can be applied from as little as 3mm thick, these are used to upgrade existing floors to give a new improved look to your industrial flooring, commercial flooring or domestic flooring surface.
PSR also specialise in using flooring screeds to level out problem floors when flooring flatness issues are a problem for forklift trucks on commercial flooring in warehouses & VNA Racking systems.
Other companies use expensive grinding methods to sort out flatness issues which is a very time consuming method & leaves the warehouse floor with grinding channels. But PSR use the overlay screed system to overcome this problem leaving the floor with a new look and the screed laid to the required tolerances, but without the problems created by using grinding methods. Dust free floor preparation is a key part of the success of the our industrial flooring screeds.
PSR use a number of different materials to solve all types of commercial flooring levelling problems and up to 1,000 sq. metres coverage of flooring can be achieved in one day.
Concrete surfaces must be sound, dry and fully cured (not subject to shrinkage). Any laitance or surface treatments must be removed by mechanical means such as dust free diamond grinding. The surface tensile strength of the substrate should be a minimum of 15 N/mm2. If an impervious coating, screed or floor covering is to be used the concrete/screed substrate should be below 75% RH alternavely Strongcoat DPM should be applied. The temperature of the floor must be maintained above 5oC throughout the application and drying of the Cemflow Base or topping. These cemflow topping products can be supplied pigmented for a wide range of aesthetic pleasing finishes.
PrimingFor application over cement screeds, concrete and other porous substrates, seal the prepared surface by applying two coats of Acrylic Primer diluted with 3 parts of potable water to one part primer and allow to dry. It is imperative that any expansion joints covered should be saw cut or mirrored and sealed.
Base Screeds & Topping Screeds
DCP Cemflow Topping Floor Screed - Product Features
Cemflow Topping Floor Screed is designed as an industrial grade floor topping for upgrading and renovating new and existing internal floors.The product is supplied as a pre-blended dry powder designed for application between 5mm to 15mm (in one application) to provide a finished floor.
Cemflow Topping floor screed is self-smoothing, dimensionally stable, and fast drying. It is suitable for use in a wide range of industrial environments such as warehouses, food processing plants etc. subjected to medium to heavy traffic.
Typically the floor screed can be pumped up to 2000m2 per day. Coverage of 600m2 can be achieved when hand applied, dependent upon manpower and equipment used.
We would recommend that Cemflow Topping be sealed in areas where water may come into direct contact with the cured material. The floor screed is best sealed with clear Strongcoat WD water based epoxy coating, or if a matt finish is required, apply a first coat of clear Strongcoat WD followed by a coat of Strongcoat Matt Clear. Cemflow Sealer can also be used to seal the product in a commercial environment.
Tel: 01226 382864
Mobile: 07782 214814
PSR Industrial Flooring are approved industrial flooring and commercial flooring contractors for clients such as Coca-Cola, Bosch, Nestlé, Laing O’Rourke, The BSS Group, Autoglass and J Radcliff.
View Case Studies